• Welcome to SCdev.org. Please log in.

Welcome to the new SCdev forums!

My Supercard is not working after using a Sandisk adapter

Started by pg65, December 10, 2005, 06:46:05 PM

Previous topic - Next topic

pg65

I have a Sandisk adpter for my minsd, I though it would work with the supercard. Before using the adapter I was getting a lot of error massages "sd locked", this would happen if the supercard had no disk or had a SD in. I would have to pull the SD out and put it back in some times more then 1 time. Now my supercard is not coming up at all.
Supercard SD, Sandisk 2 GB, AData  256 MB
Supercard One - 512MB Transcend
Pink DSL with flashme v8a Org-FW  haven't checked

cory1492

there is a little switch on the side of the SD card. If its in the wrong position then it will be locked. If you have no SD in, you should have gotten the error message "No SD found" or similar.

While it was working though, you should/could run the diagnostic, start SC in GBA mode and while the GBA Nint. logo screen is on hold L+R and use A to cycle through them.

pg65

when it 1st happen I was hoping that was it but no, I don't even get the error message no sd now. DS boots as if there is no gba card.
Supercard SD, Sandisk 2 GB, AData  256 MB
Supercard One - 512MB Transcend
Pink DSL with flashme v8a Org-FW  haven't checked