Search

[strells]

Well, I updated my SCCF to 1.8 and I updated my DSLink to 2.1.  Now, I can't get to my DSLink with the SCCF installed.  Previously, I held ABXY to get to the SCCF and didn't press anything to get to the DSLink.  Now, I always go to the SCCF by default.  What's changed and what am I doing wrong?

Steve

[jmr]

im using a scdsone & ez-flash 4 & mine boots to the ez-flash 4 first (i think cause of flashme)
i just press select to boot to my scdsone

[dai_uk]

have you tried holding  select, there are 2 versions of flashme on V8 but 7 always booted slot 2 first so I used to hold select to go to the SCDS One

[strells]

Yes.  This goes to the regular DS setup.  I think I ran some tip I found on this site about doing this and it no longer works.  I'll keep looking.

Steve

[strells]

Now I remember.  It's the header patcher found here:

http://www.scdev.org/forum/viewtopic.php?p=17303#17303

Updating to 1.8 got rid of the patch.  Anybody try this yet with 1.8?

Steve

[Mota]

Now I remember.  It's the header patcher found here:

http://www.scdev.org/forum/viewtopic.php?p=17303#17303

Updating to 1.8 got rid of the patch.  Anybody try this yet with 1.8?

Steve

The header patcher should work with any version, as they all have the same header.