Search

[nickwp]

Please help!!
My Supercard CF has completely stopped working, it isnt detected at all any more, and i've tried it in 2 DS's. :cry:
I was using it and it was working fine - never had any problems before - and then I turned the ds off, turned it back on a minute later and it didn't detect it at all - it says there is noting inserted into slot 2.
Do I need to buy a new SC?
Thanks
Nick

[nickwp]

I tried running the thing for reflashing bricked supercards if they had that virus, and it did detect the SC but didnt seem to want to flash it - it said Erasing... then said Programming 524288 bytes... but didnt do anything after that. I left it for a few minutes then turned it off.
Now when I turn it on it says there is a DS option pak inserted.
:?
I think I'll just order a new one.

[ruffnutts]

well my supercard sd is fucked same sort of thing no one seems to know or even replyed to my post

[bitblt]

I'm not sure how to help either of you.  Did you clean all contacts? Unfortunately it's not a common problem (yet) with a simple solution. I find it odd that it was working perfectly one moment, then power cycle and poof. Perhaps Romman is having issues with quality control and sent out a bad lot? Try returning your SC for replacement.  If this is not an option I would buy another SC from a different vendor (different lot).  Did you both buy from same source?  Anyone else having the same problem?

[seam]

try putting the SC or cf/sd card in the ds at a slight angle or maybe put it in then pull it out just a tad so its not too snug. i had to fiddle with my GBAMP like that sometimes before i got my SC. it would just show up as "DS option pak inserted". hope that helps.