Search

[eviled]

I would like use flashme to program my firmware.

I have a passme2 that is programmed for use with Super Mario 64 (USA) and a NDS with a v1 firmware I believe. I have an EZ Flash 2 cart (1GB) that I program with EZClient v3.25. I am using ASME-0.sav when prompted by EZClient v3.25 to prepare the flashcart with the NDSloader it puts on there.

When I try to run flashme.nds(v7) or flashme_stealth.nds (v7) I just get 2 white screens. passme2_mb.gba & passme2flashme.gba work just fine and allow me to choose the SRAM area for saving. I have saved games and gone back to them later to find the save was successful. I have only run into a few titles that either don’t boot at all or don’t get past the area in the game where you create a profile for saving (new mario, brainage, top spin 2 & met. Prime hunt).

And does using this firmware actually solve the booting/saving issues for the titles I mentioned?

Any suggestions or help would be appreciated. Thanks!

[DeVS]

No need to post the same thing in 2 diffrent forums.