• Welcome to SCdev.org. Please log in.

Welcome to the new SCdev forums!

Hori Screen Protectors. Which goes where? Red & White Ta

Started by Mikeypr, May 05, 2007, 06:45:08 AM

Previous topic - Next topic

Mikeypr

I just got some Hori Screen Protectors for my DS Lite but as the instructions are in Jap. I dont know which to use on which screen.

Does anyone know where I place the RED one and where the WHITE one goes?


Thanks

Mike

Rayder

Easiest way to tell is the top one will be a little bigger than the one for the touchscreen because the top one also goes around the border of the screen.
Current setup:
Onyx DSlite/R4DS/SCminiSD
2gig Transcend card for the SCminiSD
2gig Kingston for the R4DS
4 gigglingbytes of games/apps! WOOT!

h8uthemost

Don't mess with it until you get the instructions. These are the best screen protectors that there is for the Lite, and you don't want to mess them. Just browse around. I'm sure you'll find a copy of the instructions in English.
Setup:
White Lite
Slot 1: CycloDSx2GB Kingston Japan, Supercard DSOne+1GB Nokia(J), 16G G6 DS Real, 16G DS-Linker, R4x1GB Kingston(J),
Slot 2: G6 Lite
PSP: 3.40 OE-A

Mikeypr

I have finally plucked up the courage to put them on.

I must say they are amazing. Dont even know they are there.  Well that was untill I got fussy over a small hair caught onder the edge of the bottom screen.

Relifted it up and removed the hair, but not before touching the bottom of the screen.

Lifted it again and pulled too hard. It came right off.

Put it back on, but now there are a few specs of dust under the screen.

I really should have left alone.

That aside, They are still both totally invisible when the unit is on.

I ordered another set just to replace the bottom one with.  I have heard they are washable, but with my luck I'll screw them up totally.

Apart from that they are a doddle to fit.  No air bubbles at all.

Thanks
For Your Help.

Mike